Axial SCX30 Micro camper

Fully Printed(minus hardware) SCX30 Camper trailer! We have a Car hauler too! check our designs for more Print the tires from your desired TPU hardness, I prefer 85a or softer with very light infil in the tires. the hinges used are also designed for tpu prints, glue the front door hinge and use screws to secure the rear "hatch". You will need One M2X16mm (Or longer) for the axle shaft Nine m2x8mm four m2x5mm Also you will want two m2x4mm for the bed/storage section if its used. Assembled as shown in photos, the M2x5mm are used to secure the neck of the trailer to the bed of it from the bottom. Take care not to over tighten the axle screws otherwise the wheels may end up working themselves off. Use a scx24 stock shock ball end or a M2 screw as the ball for the hitch.