Ghostbusters Q-pack Cyclotron Vent Led mount and vent mesh Mount

This is my Q-Pack Cyclotron vent fan and led Mount and a frame to glue some mesh to cover the holes to insert before fitting the lights and fan mount. the mesh frame needs to be installed before the vent part is screwed to the cyclotron i used some fine brass mesh with about a 2mm square and glued it to the outside of the frame but leaving the grooves uncovered to fit on the splines on the inside of the vent tube. The led mount can be used without the mesh frame as it sits on the splines in the vent tube,and it has slots to sit over the screws used to mount the vent tube that stop it turning when fitted it has a protrusion that sits against the proton pack frame to allow it to not needing to be glued in place. the fan used was this https://amzn.eu/d/0afgIoVq and just clips in place (I added hot glue to fix in place ) There are openings to fit the LED's that need a layer cutting out (to minimise support in printing) there is a tube with a 6mm diameter inside measurement incorporated to add 6mm OD pipe from any home made vape style smoke machine,