{
  "$type": "site.standard.document",
  "bskyPostRef": {
    "cid": "bafyreiedmu2ozhguwv3hh4qcrr6xnhrmqbyuuhg2l7fvjalztu4pmk3zxy",
    "uri": "at://did:plc:xujdr3kkymg5kkm7hdlmdszy/app.bsky.feed.post/3mn525oji6ns2"
  },
  "coverImage": {
    "$type": "blob",
    "ref": {
      "$link": "bafkreid2n35oguv6eupujk2umpxwjs4upc5pcghufotendftfnqfotdshu"
    },
    "mimeType": "image/png",
    "size": 180343
  },
  "path": "/en/3d-model/gadget/tesla-duct-for-80x80xxx-ver-2-with-motherboard-cooling",
  "publishedAt": "2026-05-31T06:44:28.000Z",
  "site": "https://cults3d.com",
  "tags": [
    "gadget"
  ],
  "textContent": "This is a Tesla duct model for M4, P4, T4 cards. Should also fit to A2 & L4, but so far those cards have not been tested with this model (use at your own risk). Tesla card is NOT included in this model.\n\nCustom designed shroud is a perfect way of cooling a passive-heatsink NVIDIA Tesla's listed above in a desktop/workstation/server case. This shroud (together with the fan, not included) is engineered to fit precisely to the card, and to meet/exceed the card's cooling requirements. Model is optimized for good hand feel, without sharp edges & quality of design according to best engineering practices by a engineer with a degree, but also protected with logo (not shown on photo, only in STL). 3D printing material advised (for higher heat resistance): ABS, ASA, HIPS, PP, PC or Nylon.\nVersion 2 brings opening for cooling of the motherboard & outside of the Tesla, with 1/4 of fan capacity of air flow, see the opening below the card.",
  "title": "Tesla duct for 80x80xXX ver 2 - with motherboard cooling"
}