V11 Punch Suppressor - Marathon

This is a suppressor attachment for CreativiMex's V11 Punch model. You need to buy that separately.

This will require modifications to his models, either via a 3D design software, or by adding some negative parts in your slicer to create magnet holes in his models to mate with the magnets in my model. I added pictures to hopefully convey what this means.

1. Add three 14mm cylinder cutouts, 1mm deep, to the front cover. One in the exact center, and two others 35mm away (at the centerpoint of the circles) on either side.
2. Add three 14mm cylinder cutouts, 2.2mm deep (2.2, instead of 2, for tolerance), to the large front piece. One in the center of the inset part where the front cover goes, and the two others 35mm apart to match.

• Magnets are 14x3mm and you'll need 6 of them.

I included the 3MF file so you can see how I printed it. It's pretty basic, the only piece I had any problems with getting a good finish on was the front nodes, since I printed them upside down for the smooth surface finish on the pattern. It could probably be printed in the other orientation if you add ironing, or don't care about the barely-noticeable black rings and just print in straight gray.

PLA filaments used in my photos:

• Bambu Iron Gray Metallic
• eSun Cool White
• Bambu Black
• Comgrow Lemon Green

Disclaimer: I am not a professional or expert designer, I just dabble in making small things and don't usually publish them, so I won't be providing extensive support. I made it for myself, not to be perfect.