Dourif Tea Light Holder Skull - NO AMS

Dourif is a solid, chunky skull tea light holder with a simple shape and just enough detail to keep it interesting. No over-complication, no unnecessary extras, just a clean object that does its job and looks good doing it. Stick a tea light in, put it on a desk or shelf, and you’re done. Details Designed for LED / fake tea lights only Internal cutout: 40 × 40 × 40 mm Sizes Small: 3 × 2.5 × 2.5 inches Large: 4 × 3.5 × 2.5 inches Print Options Non-AMS (Assembly Version) Printed in separate parts. The pieces are designed to fit precisely and click into place. However, depending on your printer calibration or filament choice, some fits may be slightly looser than intended (I found this issue with a couple of old filaments I was using up). If the pieces do not fully click into place, simply apply a small drop of glue to the back of the insert. Once seated, it will still sit cleanly. Tip: Use the end of small pliers (or similar) to press details fully flush for the cleanest finish Printing Notes Best printed in PLA Printed on its front for a cleaner front face and reduced print time Supports required for the internal “roof” area Safety Use LED tea lights only Do NOT use real candles (PLA + heat = bad time)