DK Riser for Bambu Lab X1 P1

When I made remixed my first Riser it was out of personal necessity because the built in LED in BambuLab was not sufficient and that low profile design turned out to be quite popular. Since then a couple of users Qiao112 and Dan Ljungstr m encourage me to do the next version that also has a vent on it they showed me a design from another designer which is very good but I personally like it to be not as tall So through the rabbit hole I went gone thru several design ideas throw away most of them starting over and over until I came up with something that I personally like So here it is still similar to the first design it has a TPU Bed Light Shield on top but I made several modification from the original design recognizing issues that was inherent from the first design. The first design I angled the LED 60 degrees downward the problem is if we do not want to cut the LED strips and do some soldering at the corners you have to bend the LED strips it will be very hard to fit them nicely so in the new desogn I change the angle to 45 degrees less bending at the corners and as a bonus less overhang then I added a cave for the lack of a better word so we can accommodate the extra LED to curl in there.