{
  "$type": "site.standard.document",
  "bskyPostRef": {
    "cid": "bafyreia4mrdr5m4geilffn5jivyu7ikzks465alpeczbhjvh2qfnlpv2z4",
    "uri": "at://did:plc:xujdr3kkymg5kkm7hdlmdszy/app.bsky.feed.post/3mj6nyh2gkxd2"
  },
  "coverImage": {
    "$type": "blob",
    "ref": {
      "$link": "bafkreigyqx6svqrbk2titd3apoj6xb6y2whyh2uv3fjwf6glme2765q7aq"
    },
    "mimeType": "image/webp",
    "size": 32000
  },
  "path": "/en/3d-model/home/toilet-paper-holder-mounts-to-towel-bar-holder-mount-included",
  "publishedAt": "2026-04-11T00:22:29.000Z",
  "site": "https://cults3d.com",
  "tags": [
    "home"
  ],
  "textContent": "I have been using an otherwise unused towel bar holder to hold a roll of toilet paper. This has worked well to prevent cats from unrolling it. It's not completely out of their reach though. There was nothing to stop the roll pulling off of it. An errant bounce could have sent the roll into the toilet bowl. After nearly doing this myself while trying to pull a sheet off one-handed, I decided to model this replacement with a stopper on the end. \n\nThe tube holding roll extends 129 mm from base, and is 15 mm diameter. Wall of tube is 2.5 mm thick. Front stopper extends 8.5 mm above tube.\n\nThe base is 42 mm x 56 mm, and 7.2 mm thick. The back opening of it is 31 mm x 41 mm. The bottom side has a threaded hole for 8-32 set screw. I gave this an extra 0.1 mm clearance and print still needed to be tapped. I have added another 0.1 mm to the model here, so it may not to be tapped. I used a metal set screw to hold it, but will include a printable one. That can be scaled to fit if necessary. \n\nI used the metal mount that was already attached to wall. However, a printable mount is included if needed. \n\nThe mount is 30.5 mm x 36.5 mm x 4.7 mm. There is a 2 mm recess in it for set screw. Made for use with screws up to 5 mm diameter.",
  "title": "Toilet paper holder - mounts to towel bar holder - mount included"
}