{
  "$type": "site.standard.document",
  "bskyPostRef": {
    "cid": "bafyreihm6gf37ijzyqpbity6qwagvmhjcylod2ubslg4qnyioq5bwgqj4m",
    "uri": "at://did:plc:xujdr3kkymg5kkm7hdlmdszy/app.bsky.feed.post/3mi3s5lcwvjh2"
  },
  "coverImage": {
    "$type": "blob",
    "ref": {
      "$link": "bafkreiahujhtdfezzinrmfokleevw4gxpvkywu3af4z2wvnaimwrqovcey"
    },
    "mimeType": "image/jpeg",
    "size": 48061
  },
  "path": "/en/3d-model/gadget/beeid-v1-1-m10q-holder-for-official-pavo-20-pro-o4-canopy",
  "publishedAt": "2026-03-28T03:08:36.000Z",
  "site": "https://cults3d.com",
  "tags": [
    "gadget"
  ],
  "textContent": "A little hat for the Pavo 20 Pro O4 Pro Canopy, how cute! This design specifically fits the tiny BeeID v1.1 M10Q GPS Module with RemoteID and is meant to be printed with slightly more rigid TPU.\n\nI have flown it with some pretty aggressive acro and while in flight the module stays put and survived the two medium impacts I had while testing. (The scuffed sticker on the gps was from before I had a case lol) My one gripe with this module is the tiny cable connector, so I have also added a variant with a little nob to reduce the risk of a right angle bend in where the wires are crimped.\n\nWhole lotta yap (Instructions):\n\nMake sure to remove ALL support material as the tolerances are tight to keep the module seated. I printed mine with the top of the holder on the build plate for max rigidity. To assemble, slide in the module at about a 15 degree angle with the gps module facing out. Press it in until the pcb is fully seated under the overhang and the gps is flush with the top bezel. Then, push the module down on the open end of the case so the remote ID module on the the bottom of the module is fully seated in the inner recessed rectangle and the module lays flat. Last, slide the case with module into the top hole on the pavo canopy matching the shapes until the lip on the case is fully inserted and pop the case into position by pressing on the top end of the case. Insert wiring and you're done!",
  "title": "BeeID v1.1 M10Q Holder for Official Pavo 20 Pro O4 Canopy"
}