Car Phone Holder MagSafe Swivel mount

Here is Car Phone Holder MagSafe, This awesome Design is a fully customisable adjustable and interchangeable MagSafe phone holder to fit almost any car or phone, If you can't fit your car or phone please leave a comment and I'll try my best to add another part to fit your car. The design is split into 6 parts, selecting them start with the main cradle or if your using larger double sized tape select the main cradle that has an extra 1mmm space, Next select the air vent size I recommend the medium 20x20, The LN stands for Long neck if your vents are further away, Next select your leg sizes I recommend the Medium or small, I've also included a wider hinge joint but I recommend the 24mm, Assembly to Joint the adjustable swivel ball joint to the Circle Base, Place them both on a flat table or bench, It's easier on a harder surface like stone or marble, Then Flip the joint upside down and push flat and straight down on the back of the circle joint, they will be quite tight but you'll hear a click when their in place, If your struggling with this step you can heat the circle base up with heat gun or hair dryer then insert the Ball joint, But doing this will make the joint a lot looser, Next push the cable through the front of the Main cradle then through the circle base, attach The circle base to the Main cradle after this step. Next push each of the arms into the Hinge Joint by pushing and wiggling slightly, you'll know their in place when you can clip them into the positioning slots, Now slide the assembled Hinge and stand off legs into the Main cradle, they should easily slide into the right side of the cradle under the circle base. Next slide the air vent clip over the cable using the cable slot and clip it into the other side, One side will be smaller on the air vent clip this part goes in first, on the smaller air vent clips the arrow will point to the correct direction, Next if you're happy that you have the correct parts, insert the Back slide plug into the main cradle If your using PLA the parts should be tight enough without using glue, but if your using PETG you'll need to apply a bit of glue in between the circle base and the main cradle and behind the air vent clip but make sure you do this after you install the MagSafe charger and cable.